Firewood by species / Hardwood
Extension tables · checked 2026-10-20
White ash firewood
A cord of white ash holds about 24.6 million Btu of heat, according to the University of Kentucky forestry table (at 20% moisture content). That ranks it #15 of 52 species on this site, 23% more than the 20 million Btu the U.S. Energy Information Administration uses for a generic cord of wood.
- 1Heat per cord 24.6 million Btu
- 2Rank of 52 #15
- 3Dry weight 3,472 lb/cord
- 4Splitting Medium
How much heat is in a cord of white ash?
The two extension tables used here disagree by 0.4 million Btu: Kentucky lists 24.6 and Utah State lists 24.2 (as "Ash, White"). The figures are close, so either one gives nearly the same answer in the calculator. Cord Calc uses Kentucky's figure because its table states the moisture basis (20%). It sits 3.9 million Btu above the median species (20.75), and it is #14 of the 38 hardwoods listed, whose average is 22.1 million Btu.
One cord of gambel oak, the highest in the table, holds as much heat as 1.25 cords of white ash. In the other direction, a cord of white ash replaces 1.78 cords of buckeye (horsechestnut), the lowest. In energy terms one cord equals the heat content of about 178 gallons of heating oil, using EIA's 138,500 Btu per gallon; the stove and the oil burner each lose some of that before it reaches the room.
Cords of white ash for a winter
For the example house used across this site (2,000 sq ft, built in the 1970s, wood as the only heat, a 74% efficient stove), a normal winter takes:
| State | Degree days | White ash | Generic cord (20 M Btu) |
|---|---|---|---|
| North Dakota (coldest) | 9,184 | 5.6 cords | 6.9 cords |
| Oregon (median) | 5,269 | 3.2 cords | 3.9 cords |
| Florida (mildest) | 646 | 0.4 cords | 0.5 cords |
Because white ash beats the generic cord, the stack is 19% smaller than the same winter on average wood. Your own house will differ; the calculator takes your state, floor area, house age and price.
Weight, splitting and how it burns
- Weight: Utah State lists 3,952 lb per cord green and 3,472 lb air-dried, so drying takes about 480 lb of water out of every cord. That is 27.1 lb per cubic foot of stacked cord, and roughly 1,736 lb for the half cord a full-size pickup bed holds.
- Kentucky's table puts a cord at 2,992 lb, 480 lb lighter than Utah State's dry figure.
- Splitting: medium (Utah State); Kentucky rates its splitting excellent.
- Burning: low smoke, few sparks, good coals, slight fragrance.
- Overall rating (Utah State): excellent.
- Water in the living tree: 45% moisture content (Kentucky), among the driest in the table, so it seasons sooner than most.
Whatever the species, the heat figures assume dry wood. Seasoned firewood is below 20% moisture; fresh-cut wood is 35 to 50% water by weight (CMHC), and burning it wastes heat boiling that water off. The seasoning guide and the moisture meter guide explain how to get there and check it.
What a cord of white ash is worth
Maine's Governor's Energy Office surveyed dealers at $355 a cord on September 21, 2026 (seasoned wood, minimum 2-cord purchase, local delivery included). Paid for as white ash, that is $14.43 per million Btu in the wood, or $19.50 per million Btu delivered by a 74% stove. It sits in the middle of the table, so a flat per-cord price is roughly fair for it. Only two states publish a dated cord price; see Maine and New Hampshire.
Similar species
- Honey locust: 24.6 million Btu per cord (#14)
- Blue ash: 23.8 million Btu per cord (#16)
- Mulberry: 25.8 million Btu per cord (#13)
- Pin oak: 25.9 million Btu per cord (#10)
Compare every species on the firewood BTU chart, or see what a cord, face cord and rick hold before you buy.
Sources: University of Kentucky Forestry, Comparison of Properties Affecting Firewood (row "White ash"); Utah State University Extension Forestry, Wood Heating (Kuhns and Schmidt), Table 1 Firewood Facts (row "Ash, White"). Last checked 2026-10-20. Price: Maine Governor's Energy Office, 2025-2026 Heating Season Weekly Fuel Prices (September 21, 2026). Method: methodology.